Rear Suspension Enhancement System compatible for Dodge Ram 2500 03-2010 compatible for Ram 2500 2011-2013

SKU

300200009478

Skip to the beginning of the images gallery

Application

Compatible for Dodge RAM 1500 (2002-2005) 2WD
compatible for Dodge RAM 1500 (2006-2008) 2WD Mega Cab
compatible for Dodge RAM 1500 (2002-2005) 4WD
compatible for Dodge RAM 1500 (2006-2008) 4WD Mega Cab
compatible for Dodge RAM 2500 (2003-2010) 2WD Laramie
compatible for Dodge RAM 2500 (2003-2010) 2WD ST
compatible for Dodge RAM 2500 (2003-2010) 2WD STL
compatible for Dodge RAM 2500 (2003-2010) 2WD SXT
compatible for Dodge RAM 2500 (2003-2010) 4WD Laramie
compatible for Dodge RAM 2500 (2006-2010) 4WD Power Wagon
compatible for Dodge RAM 2500 (2003-2010) 4WD ST
compatible for Dodge RAM 2500 (2003-2010) 4WD STL
compatible for Dodge RAM 2500 (2003-2010) 4WD SXT
compatible for RAM 2500 (2011-2013) 2WD Laramie
compatible for RAM 2500 (2013) 2WD Tradesman
compatible for RAM 2500 (2011-2013) 4WD Laramie
compatible for RAM 2500 (2011-2013) 4WD Power Wagon
compatible for RAM 2500 (2013) 4WD Tradesman

Specification

Condition: Brand New
Drilling Required: No
Material: Rubber Spring
Placement on Vehicle: Rear left and right
Package Length, width and height: 30*29*17 cm
Package Wight: 4.7Kg
Rubber spring---
Load capacity: Up to 6000 LBS
Design height: 130 mm
Stroke: 65 mm
Max. Extended: 130 mm
Min. Compressed: 65 mm
Package includes（as the picture shows）:
2x Pre-Assembled Rubber springs
1x Installation instruction
Includes hardware needed to Install

Feature

1. Ease of installation: Directly replace the bump stop of the original car.
2. Ease of use: Requires zero maintenance.
3. Reliability: No air leaking, No need for air lines and compressors.
4. Stability: Reduce the sag of the rear end of the car and soften sharp rebounds.
5. Quality: High-quality rubber that has been verified many times.

Note

1. This product will not increase the load capacity of your vehicle.
2. Do not exceed the manufacturer's recommended weight limit.
3. All modifications must be installed by qualified personnel and in compliance with your local modification regulations.
4. It is necessary to ensure that there is at least 1/2" of gap between the kit and the frame when the car is empty.